sr_postprocess

sr_postprocess applies a gray/noise postprocess effect while the actor is inside a restrictor and applies periodic radiation and shock hits.

Use it for hazardous visual zones where the actor should see an effect and take damage while inside.

Parameters

intensity

Type: number. Required. Default: none.

Target postprocess intensity. The value is multiplied by 0.01.

intensity_speed

Type: number. Required. Default: none.

Ramp speed for entering and leaving the zone. The value is multiplied by 0.01.

hit_intensity

Type: number. Required. Default: none.

Damage accumulation rate while the actor is inside.

Common switch fields are parsed, but switching away calls PostProcessController.deactivate(), which currently aborts. Keep this section active; leaving the zone already ramps the effect down and stops damage accumulation.

Behavior

On activation, the manager starts a postprocess effector with id object.id() + 2000. Each update:

• checks common switch conditions first;
• tests whether the actor is inside the restrictor;
• ramps intensity toward the target when inside and back toward zero when outside;
• updates gray color and noise parameters;
• accumulates hit power while inside;
• once per second, applies radiation and shock hits to the actor.

intensity and intensity_speed are converted from percent-style values by multiplying by 0.01. hit_intensity is used directly as the per-second accumulation rate.

Example

[logic]
active = sr_postprocess@hazard

[sr_postprocess@hazard]
intensity = 40
intensity_speed = 8
hit_intensity = 0.02

Notes

• intensity and intensity_speed are percent-style config values.
• The hit direction is zero and impulse is 0.